Mitsubishi Electric MELSEC-Q Series User Manual page 76

(2) Setting on the window in the table format
Item
Select a link device assignment method.
• Points/Start: Enter the points and start numbers of
Assignment Method
• Start/End: Enter the start and end numbers of link
The number of stations set in "Total Stations" of the
Number of PLCs
network settings is displayed.
Enter the station number of each slave station
connected to the network.
Station numbers do not need to be set consecutively,
Station No.
but must be unique.
The station number of the master station is fixed at
"0".
Select the type of stations (excluding the master
Station Type station). Select the station type of modules actually
connected to the network.
(Note-1): The range from the station No.1 to 4 is valid in the 4-axis module, and the range from the station No.1 to 8 is valid in the 8-axis
module.
1) Set network setting parameters. (Refer to Section 7.3.)
2) Open the setting window.
Project window
[Ethernet/CC IE/MELSECNET]
3) Set parameters in the window.
4) Click the [End] button.
Description
link devices.
devices.
[Parameter] [Network Parameter]
[Network Configuration Settings] button
• Points/Start
• Start/End
(Default: Start/End)
1 to 120
(Default: Consecutively numbered)
(1) Station No.1 to 16
• Intelligent Device Station
• Remote Device Station
(2) Station No.17 to 120
• Intelligent Device Station
• Remote Device Station
• Remote I/O Station
(Default: Intelligent Device Station)
7 - 16
Chapter 7 PARAMETER SETTING
Setting range
–
(Note-1)
Remark
–
–
–
If the value
outside the setting
range is set,
"Parameter error
(error code:
D628H)" will
occur.