Mitsubishi Electric MELSEC-Q Series User Manual page 72

Item
Set this item to reserve the slave station from the
station No.17 to 120. (Refer to Section 8.5.)
• No Setting
• Reserved Station
Reserved/Error
Invalid Station
• Error Invalid Station
Alias This item cannot be set for the Simple Motion module. All invalid.
Comment This item cannot be set for the Simple Motion module. All invalid.
Set the station-specific mode of the slave station. This
Station-specific mode
setting is available only when the slave station
setting
supports the station-specific mode.
The slave stations are listed. Drag and drop the
modules from "Module List" to the station list area or
Module List
the device map area to set the information of the
slave stations into the master station.
(Note-1): The range from the station No.1 to 4 is valid in the 4-axis module, and the range from the station No.1 to 8 is valid in the 8-axis
module.
(b) Change Transmission Path Method
[CC IE Field Configuration]
Item
Change
Transmission
Path Method
Description
The slave station is connected to the network.
The slave station is reserved for future expansion.
By reserving a slave station, link device assignment
will not change even if the slave station is added or
the reservation is cancelled. Therefore, the program
needs not to be modified. Physical connection of the
slave station is not required.
This item cannot be set for the Simple Motion
module.
The transmission path method cannot be changed. The ring
connection is not supported.
• No Setting
• Reserved Station
(Default: No Setting)
The setting varies depending on the
set module.
[Change Transmission Path Method]
Description
7 - 12
Chapter 7 PARAMETER SETTING
Setting range
–
Setting range
• Line/Star
(Default: Line/Star)
Remark
•If the invalid
station is set,
"Parameter error
(error code:
D301H)" will
occur.
•All invalid for the
station No.1 to
(Note-1)
16
.
–
–
–
–