Toshiba Infinia 7130 Series Maintenance Manual page 103

Procedure 1
The purpose of this procedure is to determine if the InTouch ™ Module cable and connector
are damaged or improperly connected to the USB port. To perform this procedure, begin
with Check 1 and continue as instructed.
Check 1 (A) Inspect the InTouch™ Module's cable and connector for damage. (B) Verify
that the module's cable is properly connected to the USB port. (C) Replace parts
as necessary or properly connect the module connector to the USB port (refer to
section 4.16.). (D) Test the module to determine if the problem still exists.
If the problem still exists, perform Procedure 2. If the problem no longer exists,
perform Check 2.
Check 2 Determine if the original problem still exists.
If the original problem still exists, perform the Problem Definition Process. If the
original problem no longer exists, perform the Repair Completion Process.
Procedure 2
The purpose of this procedure is to determine if expansion cards are causing the problem with
the InTouch™ Module. To perform this procedure, perform the following Check.
Check (A) Remove all expansion cards installed in the computer (refer to section 4.4. and
4.5. as necessary). (B) Test the InTouch ™ Module to determine if the problem
still exists.
If the problem still exists, perform Procedure 8. If the problem no longer exists,
perform Procedure 3.
Infinia™ 7130, 7160, and 7200 Maintenance Manual ---------------------------------------- 3-96
InTouch™ Module Cable/Connector Check
Expansion Card Removal Check