Toshiba Infinia 7130 Series Maintenance Manual page 159

NOTE: When connecting switch and LED cables, make sure the printed side of
the connector faces the board, except for the LED connector labeled POWER
LED. For this LED, the printed side of the connector faces away from the
board. Refer to section 4.1.3.4.
1. Connect the power switch cable to the pins labeled PWR ON (black cable to pin 1 and
yellow cable to pin 2) on the system board.
2. Connect the sleep switch cable to the pins labeled SLEEP (black cable to pin 3 and
white cable to pin 4) on the system board.
3. Connect the HDD LED cable to the pins labeled HD LED (blue cable to pin 16 and
black cable to pin 15) on the system board.
4. Connect the power LED cable to the pins labeled SLEEP LED (black cable to pin 18
and green cable to pin 20) on the system board.
5. Connect the reset switch cable to the pins labeled RESET (black cable to pin 22 and
red cable to pin 23) on the system board.
6. Replace the computer's right-side panel (refer to section 4.2.2.), left-side panel (refer
to section 4.2.6.), and rear bezel (refer to section 4.2.4.), as viewed from the rear.
7. Connect the power cord and all external cables to the computer and turn on the power.
Infinia™ Series Maintenance Manual --------------------------------------------------------- 4-152
Figure 4-27 Switch and LED Cable Connections