Intouch™ Module; Removing The Intouch™ Module; Replacing The Intouch™ Module - Toshiba Infinia 7130 Series Maintenance Manual

InTouch™ Module
This section covers the removal and replacement of the InTouch™ Module.
Removing the InTouch™ Module
To remove the InTouch™ Module, turn off power to the computer and disconnect the
Module cable connector from the first USB port (color-coded white) in the rear of the
computer. On the back of the Module, slide the latch down to release the module from the
mounting bracket on the monitor. See Figure 4-35.
Figure 4-35 Removing and Replacing the InTouch™ Module
Replacing the InTouch™ Module
To replace the InTouch™ Module, route the Module cable under the monitor. Align the
Module cable connector with the first USB port (color-coded white) in the rear of the
computer. Adjust the connector so that the pins on the connector align with the holes in the
port. Push the connector into the port. Restore power to the computer.
Appendix A
Infinia™ Series Maintenance Manual --------------------------------------------------------- 4-161