Removing The Rear Bezel - Toshiba Infinia 7130 Series Maintenance Manual

Removing the Rear Bezel

To remove the computer's rear bezel, perform the following procedure and refer to Figure 4-
9.
1. Turn off power to the computer, then disconnect the power cord and all external
cables connected to the computer.
2. Remove the right-side panel (refer to section 4.2.1.), as viewed from the rear.
NOTE: When performing the next step, notice that the top tab is blocked by the
power supply, making it impossible to press in on the tab. After releasing the
bottom and middle tabs, the top tab should release when you pull the bezel away
from the chassis. If it does not release, press the tab forward until it is free of its
latch.
1. Press in on the bottom and middle tabs on the inside right of the rear chassis.
2. Pull the bezel away from the chassis.
Figure 4-9 Removing and Replacing the Rear Bezel
Infinia™ Series Maintenance Manual --------------------------------------------------------- 4-128