Replacing Expansion Cards; Changing Jumper Settings; Assembly Reminders - Toshiba Infinia 7130 Series Maintenance Manual

Figure 4-6 Normal Pin and Latch Connectors

Replacing Expansion Cards

Depending on the model, the Infinia™ is shipped with both a modem card and a TV Tuner
Card (7200, 7201, or 7220) or just a modem card (7130, 7160, and 7161). As of shipping,
the modem card is inserted in the middle ISA slot and the TV Tuner Card is inserted in the
middle PCI slot. When replacing the modem card and the TV Tuner Card, be sure to install
these cards in the same slot you removed them from; failure to do so could cause software
configuration problems.

Changing Jumper Settings

The system board has configuration jumpers that allow you to change the system
configuration. A jumper is a small plastic-encased conductor that slips over jumper pins.
To change a jumper setting, use a pair of needle-nosed pliers to remove the jumper from its
current location and slide it onto the new pins to obtain the desired settings. See Figure 4-7.
Figure 4-7 Changing Jumper Settings

Assembly Reminders

While assembling the computer, remember the following general points:
Infinia™ Series Maintenance Manual --------------------------------------------------------- 4-122