Table of Contents
Advertisement
10.
Jumper Settings for MIB (Motion Interface Board)
The Motion Interface Board (MIB) is installed in the Control Unit. It enables
communication between the Control Unit and Drive Unit. The maximum number of
MIBs that can be installed in one Control Unit is three (3).
JP9
JP10
JP1
The tables below show the MIB jumper settings. The settings shown in gray are the
default settings at ship time. Usually, the default settings do not need to be changed.
Each time an additional MIB is installed, the software needs to be configured accordingly
in addition to the jumper settings. For further details, refer to the following manual.
EPSON RC+ : User's Guide - the section RC520 Drive Unit Software Configuration
SPEL CT
RC520 Rev.7
JP2 JP3
JP11
JP4
in the chapter Motion Systems
: User's Guide Setup & Operation - 11.3 Setting Up the Hardware
Setup & Operation 10. Jumper Settings for MIB
JP7
JP6
JP5
JP8
103
Advertisement
Table of Contents
