Table of Contents
Advertisement
Setup & Operation 2.4 Control Unit (Part Names and Functions)
2.4.3 Rear Panel
Names and functions for the rear panel components are as follows:
NOTE
The types of power receptacle and CPU board (connectors for mouse and keyboard) are
different depending on the shipping date. The Controller in which the parts have been
replaced for maintenance can be different from the figures below.
(1) IEEE-1284 (parallel) connector:
(2) MIB (Motion Interface Board):
(3) DU number label:
(4) Serial connector (RS-232C):
16
(1)
(8)
(9)
(1)
(9)
(14)
Receptacle for printer cable.
For EPSON RC+ Users, this connector is for the EPSON RC+ software key.
This board is used for communication between the Control Unit and the Drive Unit.
The Control Unit has one MIB mounted in one of its expansion slots for each Drive
Unit connected.
The maximum number of MIBs that can be mounted in the
Control Unit is three (3).
This label is attached on the MIB slot to specify which Drive Unit to be connected.
You may confirm this number (DU1, DU2 or DU3) also on the Connection Check
Label on the front panel where the appropriate DU number for each Drive Unit is
indicated.
This connector facilitates data communication and centralized control by connecting
peripheral equipment and a host computer.
For settings, refer to the Setup & Operation 9. RS-232C Settings.
(2) (3)
(4)
(5)-1
(10)
(11)
(12)
(13)
(2) (3)
(4)
(5)-2
(10)
(11)
(15)
(6)
(7)
(10)
(6)
(7)
(10)
RC520 Rev.7
Advertisement
Table of Contents
