Recovering The Hdd; Recovering Windows - Epson RC520 Manual

8. Recovering the HDD

This chapter describes the procedure for recovering the current HDD in the RC520
Embedded OS is installed in.
Follow the procedure below to recover the HDD.
1 Backing Up the Current Data Settings

2 Recovering Windows

3 Configuring Windows
4
5 Restoring the Backup Data
Please prepare the parts below.
Recovery CD
EPSON RC+ setup CD-ROM or SPEL CT setup disks
PS/2 keyboard
PS/2 mouse
NOTE
USB keyboard and USB mouse cannot be used for Windows recovery. Be sure to use
PS/2 keyboard and PS/2 mouse.
8.1 Recovering Windows
■
When the Windows is recovered, all the data in the HDD will be erased. Make
sure to make a back up of data before recovering Windows. The procedure for
backup is described in Maintenance 2.5 Backup of Data.
■
When the Windows is recovered, all the partition including the created partition in
the HDD will be erased and only the C drive will remain. All the data in the HDD
CAUTION
will be erased. Make sure to make a back up of data before the recovery. The
procedure for backup is described in Maintenance 2.5 Backup of Data.
When you accidentally turn ON the RC520 with the recovery CD in its CD-ROM drive,
NOTE
the RC520 will start from the recovery CD. In this case, turn OFF the Controller before
the restore begins. The restore will not begin until you click the <Yes> button in the
following procedure (9).
(1) Connect the PS/2 key board and the PS/2 mouse. (The USB key board and the USB
(2) Turn ON the RC520.
(3) Set the recovery CD to the CD-ROM drive.
RC520 Rev.7
Recovery Procedure
Setting Up EPSON RC+
Setting Up SPEL CT
Parts
mouse cannot be used in Windows recovery.)
Maintenance 8. Recovering the HDD
Reference
Maintenance 2.5 Backup of Data
Maintenance 8.1 Recovering Windows
Maintenance 8.2 Configuring Windows.
Maintenance 8.3 Setting Up EPSON RC+
Maintenance 8.4 Setting Up SPEL CT
Maintenance 2.5 Backup of Data
Attachment to RC520
Only USB keyboard users
Only USB mouse users
Note
185