Replacing The Hdd (Hard Disk Drive); Replacing The Emergency Connector Plate Kit - Epson RC520 Manual

Maintenance 4. Control Unit

4.8 Replacing the HDD (Hard Disk Drive)

■ Do not shock, shake, or drop any parts during maintenance. When the parts
related with data (the CD-ROM drive, FDD, HDD, etc.) are shocked physically,
they may be damaged and may also cause data loss during data
loading/saving.
CAUTION
Back up the necessary data of the project and system before replacing the HDD. Then,
NOTE
restore the data of the project and system after the replacement.
Refer to the Maintenance 2.5 Backup of Data for details of data backup/restore.
(1) Shut down Windows. Turn OFF the power on both the Control and Drive Units.
(2) Open the front door of the Control Unit.
(3) Insert the key to the HDD key lock and turn the key to the right.
(4) Pull out the HDD.
(5) Install a new HDD. Insert the key to the HDD key lock and turn the key to the left.
NOTE
Refer to the instructions supplied with the new HDD for new hard disk settings.

4.9 Replacing the Emergency Connector Plate Kit

When replacing an Emergency Connector Plate Kit, refer to the Maintenance 4.2
Replacing the MIB and follow the same procedure. Refer to the figure below and
connect the MIB and emergency connector board with the cable.
MIB
142
Emergency Connector
Junction Cable
Emergency Connector Board
HDD Key Lock
RC520 Rev.7