Snmp-Server Group - Dell PowerEdge M420 Reference Manual

console(config)# snmp-server filter user-filter
ifEntry.*.1 included

snmp-server group

Use the snmp-server group command in Global Configuration mode to
configure a new Simple Management Protocol (SNMP) group or a table that
maps SNMP users to SNMP views. To remove a specified SNMP group, use
the no form of this command.
Syntax
snmp-server group
notifyview
notify
writeview
]
no snmp-server group
contextname
context
groupname — Specifies the name of the group. (Range: 1-30 characters.)
•
v1 — Indicates the SNMP Version 1 security model.
•
• v2 — Indicates the SNMP Version 2 security model.
• v3 — Indicates the SNMP Version 3 security model.
• noauth — Indicates no authentication of a packet. Applicable only to the
SNMP Version 3 security model.
auth — Indicates authentication of a packet without encrypting it.
•
Applicable only to the SNMP Version 3 security model.
• priv — Indicates authentication of a packet with encryption. Applicable
only to the SNMP Version 3 security model.
contextname — Provides different views of the system and provides the
•
user a way of specifying that context.
notifyview — Defines a string that is the name of the view that enables
•
specifying an inform or a trap. If unspecified, nothing is defined for the
notify view. (Range: 1-30 characters.)
readview — A string that is the name of the view that enables the you to
•
view only the contents of the agent. If unspecified, all the objects except
for the community-table and SNMPv3 user and access tables are available.
(Range: 1-30 characters.)
1492
SNMP Commands
groupname
{ v1 | v2 | v3 { noauth | auth | priv } [
contextname
] } [ context
groupname
{ v1 | v2 | v3 { noauth | auth | priv } } [
]
readview
] [ read ] [ write