Redistribute; Router-Id - Dell PowerEdge M420 Reference Manual

redistribute

Use the redistribute command in Router OSPFv3 Configuration mode to
configure the OSPFv3 protocol to allow redistribution of routes from the
specified source protocol/routers.
Syntax
redistribute {static | connected} [metric
tag
]
no redistribute {static | connected} [
metric — Metric value used for default routes. (Range: 0-16777214)
•
tag — Tag. (Range: 0-4294967295)
•
Default Configuration
2 is the default value for metric-type, 0 for
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the OSPFv3 protocol to allow
redistribution of routes from the specified source protocol/routers.
console(config)#ipv6 router ospf
console(config-rtr)#redistribute connected

router-id

Use the router-id command in Router OSPFv3 Configuration mode to set a
4-digit dotted-decimal number uniquely identifying the Router OSPF ID.
metric
] [metric-type {1 | 2}] [tag
metric
] [metric-type] [
tag
.
OSPFv3 Commands
tag
]
1179