Dot1X Timeout Supp-Timeout - Dell PowerEdge M420 Reference Manual

console(config-if-1/0/1)# dot1x timeout server-
timeout 3600

dot1x timeout supp-timeout

Use the dot1x timeout supp-timeout command in Interface Configuration
mode to set the time that the switch waits for a response before
retransmitting an Extensible Authentication Protocol (EAP)-request frame to
the client. To return to the default setting, use the no form of this command.
Syntax
seconds
dot1x timeout supp-timeout
no dot1x timeout supp-timeout
seconds
— Time in seconds that the switch should wait for a response to an
EAP-request frame from the client before resending the request. (Range:
1–65535)
Default Configuration
The period of time is set to 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Change the default value of this command only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
Example
The following example sets the time for the retransmission of an EAP-request
frame to the client to 3600 seconds.
console(config-if-1/0/1)# dot1x timeout supp-timeout
3600
778
802.1x Commands