Show Interfaces Status - Dell PowerEdge M420 Reference Manual

console>show interfaces description
Port Description
---- -----------------------------------------------------
1/0/1 Port that should be used for management only
2/0/1
2/0/2
Ch Description
---- -----------
1 Output

show interfaces status

Use the show interfaces status command in User EXEC mode to display the
status for all configured interfaces.
Syntax
show interfaces status [gigabitethernet
channel-number | tengigabitethernet unit/slot/port ]
The displayed port status information includes the following:
Field
Port
Type
Duplex
Speed
Neg
Link State
386
Ethernet Configuration Commands
Description
The port or port channel number. Oob means Out-of-Band
Management Interface.
The port designated IEEE shorthand identifier. For example,
1000Base-T refers to 1000 Mbps baseband signaling including both
Tx and Rx transmissions.
Displays the port Duplex status.
Refers to the port speed.
Describes the Auto-negotiation status.
Displays the Link Aggregation status, either Up or Down.
unit/slot/port
| port-channel
port-