Command Groups - Dell PowerEdge M420 Reference Manual

Command Groups

The system commands can be broken down into three sets of functional
groups, Layers 2, Layer 3, and Utility.
Table 1-1. System Command Groups
Command Group
Layer 2 Commands
AAA
ACL
Address Table
Auto-VoIP
CDP Interoperability
Data Center Bridging
DHCP l2 Relay
DHCP Management
Interface
Dynamic ARP Inspection Configures for rejection of invalid and malicious ARP
Ethernet Configuration
Ethernet CFM
IGMP Snooping
IGMP Snooping Querier Configures IGMP Snooping Querier and displays IGMP
IP Addressing
IPv6 ACL
IPv6 MLD Snooping
74
Command Groups
Description
Configures connection security including authorization
and passwords.
Configures and displays ACL information.
Configures bridging address tables.
Configures Auto VoIP for IP phones on a switch.
Configures Cisco Discovery Protocol (CDP).
Provides priority-based flow control that can pause
(inhibit transmission) of individual priorities within a
single physical link.
Enables the Layer 2 DHCP Relay agent for an interface.
Configures DHCP snooping and whether an interface is
trusted for filtering.
packets.
Configures all port configuration options for example
ports, storm control, port speed and auto-negotiation.
Configures and displays GVRP configuration and
information.
Configures IGMP snooping and displays IGMP
configuration and IGMP information.
Snooping Querier information.
Configures and manages IP addresses on the switch.
Configures and displays ACL information for IPv6.
Configures IPv6 MLD Snooping.