Port Security - Dell PowerEdge M420 Reference Manual

Syntax
mac address-table static
port-channel | tengigabitethernet}
no mac address-table static
{gigabitethernet | port-channel | tengigabitethernet}
Syntax Description
Parameter
mac-address
vlan-id
interface-id
Default Configuration
No static addresses are defined. The default mode for an added address is
permanent.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example adds a permanent static MAC-layer station source
address 3aa2.64b3.a245 to the MAC address table.
console(config)# mac address-table static
3AA2.64B3.A245 vlan 1 interface gigabitethernet 1/0/8

port security

Use the port security command in Interface Configuration mode to disable
the learning of new addresses on an interface. To enable new address learning,
use the no form of the port security command.
mac-addr
vlan
interface-id
mac-addr
Description
A valid MAC address in the format xxxx.xxxx.xxxx.
Valid VLAN ID (1-4093)
A valid physical unit/slot/port or port-channel number.
vlan-id
interface {gigabitethernet |
vlan-id
vlan [interface
Address Table Commands
interface-id]
269