Interface Range - Dell PowerEdge M420 Reference Manual

NOTE:
Additional forms of the interface command enable configuring VLANs,
tunnels, the loopback interface, the out-of-band interface, and ranges of interfaces.
See interface vlan, interface tunnel, interface loopback, and interface range.
Syntax
interface {gigabitethernet
| tengigabitethernet
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
Interface Configuration
User Guidelines
It is possible to enter interface configuration mode from global configuration
mode or from interface configuration mode.
Example
The following example enables gigabit port 2 on stack member 1 for
configuration.
console(config)# interface gigabitethernet 1/0/2
console (config-if)#

interface range

Use the interface range command in Global Configuration mode to execute a
command on multiple ports at the same time.
NOTE:
An additional form of this command enables configuring a range of VLANs.
See interface range vlan.
Syntax
interface range {
376
Ethernet Configuration Commands
unit/slot/port
unit/slot/port
port-rang port-type
e |
| port-channel
}
all}
port-channel-number