No Lacp - Dell PowerEdge M420 Reference Manual

Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example assigns an administrative LACP timeout for port 1/0/8
to a long timeout value.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#lacp timeout long

no lacp

Use the no lacp command to set the LACP (Link Aggregation) mode to
default for that Aggregator Group. The default LACP mode is dynamic.
Syntax
no lacp
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
Example
console(config)#port-aggregator group 2
console(config-aggregator-2)#no lacp
console(config-aggregator-2)#
585
Port Channel Commands