Mvr Type - Dell PowerEdge M420 Reference Manual

Syntax
mvr immediate
no mvr immediate
Parameter Description
This command does not require a parameter description.
Default Configuration
The default value is Disabled.
Command Mode
Interface Config
User Guidelines
Immediate leave should only be configured on ports with a single receiver.
When immediate leave is enabled, a receiver port will leave a group on receipt
of a leave message. Without immediate leave, upon receipt of a leave
message, the port sends an IGMP query and waits for an IGMP membership
report.
Example
console(config)#interface Gi1/0/1
console(config-if-Gi1/0/1)#switchport access vlan 10
console(config-if-Gi1/0/1)#mvr
console(config-if-Gi1/0/1)#mvr type receiver
console(config-if-Gi1/0/1)#mvr mode dynamic
console(config-if-Gi1/0/1)#mvr immediate

mvr type

Use the mvr type command in Interface Config mode to set the MVR port
type. Use the no form of this command to set the MVR port type to None.
555
Multicast VLAN Registration Commands