Classofservice Trust - Dell PowerEdge M420 Reference Manual

User Guidelines
This command has no user guidelines.
Example
The following example displays mapping for IP DSCP 1 and traffic class 2.
console(config)#classofservice ip-dscp-mapping 1 2

classofservice trust

Use the classofservice trust command in either Global Configuration mode
or Interface Configuration mode to set the class of service trust mode of an
interface. To set the interface mode to untrusted, use the no form of this
command.
Syntax
classofservice trust {dot1p | untrusted | ip-dscp}
no classofservice trust
• dot1p — Specifies that the mode be set to trust dot1p (802.1p) packet
markings.
untrusted — Sets the Class of Service Trust Mode for all interfaces to
•
Untrusted.
• ip-dscp — Specifies that the mode be set to trust IP DSCP packet
markings.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode or Interface Configuration (gigabitethernet,
port-channel, tengigabitethernet) mode
User Guidelines
This command has no user guidelines.
606
QoS Commands