If no configured/elected BSR's exist on the router, the following message is
displayed:
No BSR's exist/learned on this router.
show ipv6 pim interface
Use the show ipv6 pim interface command to display the PIM interface
status parameters. If the interface number is not specified, this command
displays the status parameters of all the PIM-enabled interfaces.
Syntax
show ipv6 pim interface [ vlan
Parameter Description
Parameter
vlan-id
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC, Privileged EXEC modes
User Guidelines
There are no user guidelines for this command. Field descriptions are shown
in the table below.
Field
Mode
Interface
Hello Interval
Join-prune Interval
DR Priority
952
IPv6 PIM Commands
vlan-id
Description
A valid VLAN ID for which multicast routing has been enabled.
Description
Active PIM protocol
Interface number
Hello interval value
Join-prune interval value
DR priority configured on this interface
]