Redistribute - Dell PowerEdge M420 Reference Manual

Default Configuration
Passive interface mode is disabled by default.
Command Mode
Router OSPF Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface vlan 1

redistribute

Use the redistribute command in Router OSPF Configuration mode to
configure OSPF protocol to allow redistribution of routes from the specified
source protocol/routers. Use the no version of the command to disable
redistribution from the selected source or to reset options to their default
values.
Syntax
redistribute protocol [metric metric-value] [metric-type type-value] [tag
tag-value] [subnets]
no redistribute protocol [metric] [metric-type] [tag] [subnets]
Parameter Description
Parameter
protocol
static
connected
1112
OSPF Commands
Description
rip - Specifies RIP as the source protocol.
static - Specifies that the source is a static route.
connected - Specifies that the source is a directly connected
route.
Specifies that the source is a static route.
Specifies that the source is a directly connected route.