Interface Vlan - Dell PowerEdge M420 Reference Manual

Default Configuration
The default for this command is 802.1Q. The default S-TAG TPID, when
double-tagging is enabled, is 0x88A8. The default C-TAG TPID when double
vlan tagging is enabled is 0x8100.
Command Mode
Global Configuration, Interface Configuration mode
User Guidelines
This command configures the TPID value on the outer VLAN (S-VLAN).
The global configuration form of the command configures all physical and
port-channel interfaces to use the specified ethertype. The interface form of
the command enables/disables the use of the ethertype on the specific
interface. The ethertype used in the interface form of the command must use
the same ethertype as specified in the global configuration form of the
command. The inner vlan tag (C-TAG) is configured using the switchport
command in interface configuration mode.
Example
The following example displays configuring Double VLAN tunnel for vman
EtherType.
console(config)#dvlan-tunnel ethertype vman

interface vlan

Use the interface vlan command in Global Configuration mode to configure
a VLAN type and to enter Interface Configuration mode.
Syntax
vlan-id
interface vlan
Parameter Description
Parameter
vlan-id
Description
The ID of a valid VLAN (Range: 1–4093).
VLAN Commands
721