Dhcp L2Relay (Interface Configuration) - Dell PowerEdge M420 Reference Manual

Default Configuration
DHCP L2 Relay is disabled by default.
Command Mode
Global Configuration.
User Guidelines
There are no user guidelines for this command.
Example
console(config)#dhcp l2relay

dhcp l2relay (Interface Configuration)

Use the dhcp l2relay command to enable DHCP L2 Relay for an interface.
Use the "no" form of this command to disable DHCP L2 Relay for an
interface.
Syntax
dhcp l2relay
no dhcp l2relay
Default Configuration
DHCP L2Relay is disabled on all interfaces by default.
Command Mode
Interface Configuration (Ethernet, Port-channel).
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-1/0/1)#dhcp l2relay
312
DHCP Layer 2 Relay Commands