Dell PowerEdge M420 Reference Manual page 138

Command
ip rip send version
redistribute
router rip
show ip rip
show ip rip interface
show ip rip interface brief
split-horizon
a. For the meaning of each Mode abbreviation, see Mode Types on page 77.
Tunnel Interface
Command
interface tunnel
show interfaces tunnel
tunnel destination
tunnel mode ipv6ip
tunnel source
a. For the meaning of each Mode abbreviation, see Mode Types on page 77.
138
Command Groups
Description
Configures the interface to allow RIP control
packets of the specified version to be sent.
Configures OSPF protocol to allow
redistribution of routes from the specified
source protocol/routers.
Enters Router RIP mode.
Displays information relevant to the RIP router. PE
Displays information related to a particular RIP
interface.
Displays general information for each RIP
interface.
Sets the RIP split horizon mode.
Description
Enables the interface configuration mode for a
tunnel.
Displays the parameters related to tunnel such
as tunnel mode, tunnel source address and
tunnel destination address.
Specifies the destination transport address of
the tunnel.
Specifies the mode of the tunnel.
Specifies the source transport address of the
tunnel, either explicitly or by reference to an
interface.
a
Mode
IC
PIP
GC
PE
PE
RIP
a
Mode
GC
PE
IC
IC
IC