Ipv6 Nd Ns-Interval; Ipv6 Nd Other-Config-Flag - Dell PowerEdge M420 Reference Manual

console(config-if-vlan15)#ipv6 nd managed-config-flag

ipv6 nd ns-interval

Use the ipv6 nd ns-interval command in Interface Configuration mode to set
the interval between router advertisements for advertised neighbor
solicitations. An advertised value of 0 means the interval is unspecified.
Syntax
milliseconds
ipv6 nd ns-interval
no ipv6 nd ns-interval
milliseconds — Interval duration. (Range: 0, 1000–4294967295)
•
Default Configuration
milliseconds
0 is the default value for .
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the interval between router advertisements for
advertised neighbor solicitations at 5000 ms.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd ns-interval 5000

ipv6 nd other-config-flag

Use the ipv6 nd other-config-flag command in Interface Configuration mode
to set the "other stateful configuration" flag in router advertisements sent
from the interface.
974
IPv6 Routing Commands