Lldp Timers - Dell PowerEdge M420 Reference Manual

Example
The following example displays how to enable the LLDP receive capability.
console(config-if-1/0/3)#lldp receive

lldp timers

Use the lldp timers command in Global Configuration mode to set the
timing parameters for local data transmission on ports enabled for LLDP . To
return any or all parameters to factory default, use the no form of this
command.
Syntax
lldp timers [interval transmit-interval] [hold hold-multiplier] [reinit reinit-
delay]
no lldp timers [interval] [hold] [reinit]
transmit-interval — The interval in seconds at which to transmit local data
•
LLDPDUs. (Range: 5–32768 seconds)
hold-multiplier — Multiplier on the transmit interval used to set the TTL
•
in local data LLDPDUs. (Range: 2–10)
reinit-delay — The delay in seconds before re-initialization. (Range: 1–10
•
seconds)
Default Configuration
The default transmit interval is 30 seconds.
The default hold-multiplier is 4.
The default delay before re-initialization is 2 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
538
LLDP Commands