Ip Arp Inspection Validate - Dell PowerEdge M420 Reference Manual

no ip arp inspection trust
Default Configuration
Interfaces are configured as untrusted by default.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-1/0/3)#ip arp inspection trust

ip arp inspection validate

Use the ip arp inspection validate command to enable additional validation
checks like source MAC address validation, destination MAC address
validation or IP address validation on the received ARP packets. Each
command overrides the configuration of the previous command. For
example, if a command enables source MAC address and destination MAC
address validations and a second command enables IP address validation only,
the source MAC address and destination MAC address validations are
disabled as a result of the second command. Use the "no" form of this
command to disable additional validation checks.
Syntax
ip arp inspection validate {[src-mac] [dst-mac] [ip]}
no ip arp inspection validate {[src-mac] [dst-mac] [ip]}
• src-mac For validating the source MAC address of an ARP packet.
—
• dst-mac For validating the destination MAC address of an ARP packet.
—
• ip For validating the IP address of an ARP packet.
—
Dynamic ARP Inspection Commands
345