Change the default value of this command only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
To provide a faster response time to the user, enter a smaller number than the
default.
Example
The following example sets the number of seconds that the switch remains in
the quiet state following a failed authentication exchange to 3600.
console(config)# interface gigabitethernet 1/0/16
console(config-if-1/0/16)# dot1x timeout quiet-period
3600
dot1x timeout re-authperiod
Use the dot1x timeout re-authperiod command in Interface Configuration
mode to set the number of seconds between re-authentication attempts. To
return to the default setting, use the no form of this command.
Syntax
dot1x timeout re-authperiod
no dot1x timeout re-authperiod
seconds — Number of seconds between re-authentication attempts.
•
(Range: 300–4294967295)
Default Configuration
Re-authentication period is 3600 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
776
802.1x Commands
seconds