Mode Dvlan-Tunnel - Dell PowerEdge M420 Reference Manual

User Guidelines
Commands used in the interface range context are executed independently
on each interface in the range. If the command returns an error on one of the
interfaces, an error message is displayed and execution continues on other
interfaces.
Example
The following example groups VLAN 221 till 228 and VLAN 889 to receive
the same command.
console(config)#interface range vlan 221-228,889
console(config-if)#

mode dvlan-tunnel

Use the mode dvlan-tunnel command in Interface Configuration mode to
enable Double VLAN Tunneling on the specified interface. To disable Double
VLAN Tunneling on the specified interface, use the no form of this
command.
Syntax
mode dvlan-tunnel
no mode dvlan-tunnel
Default Configuration
disabled
By default, Double VLAN Tunneling is .
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command has no user guidelines.
723
VLAN Commands