Access-List; Commands In This Chapter - Dell PowerEdge M420 Reference Manual

classifier rule. The ACL logging feature allows these hardware hit counts to be
collected on a per-rule basis and reported periodically to the network
administrator using the system logging facility and an SNMP trap.
The PowerConnect ACL permit/deny rule specification supports a log
parameter that enables hardware hit count collection and reporting.
Depending on platform capabilities, logging can be specified for deny rules,
permit rules, or both. A five minute logging interval is used, at which time
trap log entries are written for each ACL logging rule that accumulated a
nonzero hit count during that interval. The logging interval is not user
configurable.

Commands in this Chapter

This chapter explains the following commands:

access-list

deny | permit (IP ACL)
deny | permit (Mac-Access-List-
Configuration)
ip access-group
mac access-group
mac access-list extended
access-list
Use the access-list command in Global Configuration mode to create an
Access Control List (ACL) that is identified by the parameter
The command specifies the queue identifier to which packets matching this
rule are assigned. The command may also specify the mirror or redirect
interface (unit/slot/port) to which packets matching this rule are copied or
forwarded, respectively.
The time-range parameter allows imposing time limitation on the ACL rule
as defined by the parameter
specified name does not exist, and the ACL containing this ACL rule is
applied to an interface or bound to a VLAN, then the ACL rule is applied
immediately. If a time range with specified name exists and the ACL
244
ACL Commands
mac access-list extended rename
service-acl input
show service-acl interface
show ip access-lists
show mac access-list
time-range-name
. If a time range with the
list-name
.