Dell PowerEdge M420 Reference Manual page 135

Command
ipv6 ospf transmit-delay Sets the OSPF Transmit Delay for the specified
ipv6 router ospf
maximum-paths
nsf
nsf helper
nsf helper strict-lsa-
checking
nsf restart-interval
passive-interface
passive-interface default Enables the global passive mode by default for all
redistribute
router-id
show ipv6 ospf
show ipv6 ospf abr
show ipv6 ospf area
show ipv6 ospf asbr
show ipv6 ospf border-
routers
show ipv6 ospf database Displays information about the link state
Description
interface.
Enters Router OSPFv3 Configuration mode.
Sets the number of paths that OSPF can report
for a given destination.
Enables OSPF graceful restart.
Allows OSPF to act as a helpful neighbor for a
restarting router.
Requires that an OSPF helpful neighbor exit
helper mode whenever a topology change occurs.
Configures the length of the grace period on the
restarting router.
Sets the interface or tunnel as passive.
interfaces.
Configures the OSPFv3 protocol to allow
redistribution of routes from the specified source
protocol/routers.
Sets a 4-digit dotted-decimal number uniquely
identifying the Router OSPF ID.
Displays information relevant to the OSPF
router.
Displays the internal OSPFv3 routes to reach
Area Border Routers (ABR).
Displays information about the area.
Displays the internal OSPFv3 routes to reach
Autonomous System Boundary Routes (ASBR).
Displays internal OSPFv3 routers to reach Area
Border Routers (ABR) and Autonomous System
Boundary Routers (ASBR).
database when OSPFv3 is enabled.
Command Groups
a
Mode
IC
GC
ROSV3
ROSV3
ROSV3
ROSV3
ROSV3
IC
ROSV3
ROSV3
ROSV3
PE
PE
PE
PE
UE or
PE
PE
135