Timeout - Dell PowerEdge M420 Reference Manual

source — A valid source IP address.
•
Default Configuration
The IP address is of the outgoing IP interface.
Command Mode
Radius mode
User Guidelines
User must enter the mode corresponding to a specific Radius server before
executing this command.
Example
The following example specifies 10.240.1.23 as the source IP address.
console(config)#radius-server host 192.143.120.123
console(config-radius)#source-ip 10.240.1.23

timeout

Use the timeout command in Radius mode to set the timeout value in
seconds for the designated Radius server.
Syntax
timeout
timeout
timeout — Timeout value in seconds for the specified server. (Range: 1-30
•
seconds.)
Default Configuration
The default value is 3 seconds.
Command Mode
Radius mode
RADIUS Commands
675