Ip Pim Rp-Candidate - Dell PowerEdge M420 Reference Manual

Parameter Description
Parameter
rp-address
group-address
group-mask
override
Default Configuration
None —no static multicast groups are configured for an RP .
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip pim rp-address 192.168.21.1
239.1.0.0 255.255.0.0 override

ip pim rp-candidate

Use the ip pim rp-candidate command in Global Configuration mode to
configure the router to advertise itself to the bootstrap router (BSR) router as
a PIM candidate rendezvous point (RP) for a specific multicast group range.
Use the no form of this command to return to the default configuration. This
command replaces the ip pimsm rp-candidate command.
Syntax
ip pim rp-candidate vlan {
no ip pim rp-candidate vlan
Description
The valid IPv4 address for the rendezvous point.
A valid multicast group address to be sourced from the
rendezvous point.
A mask indicating the range of multicast groups sourced from
the RP
A flag indicating that the static entry should override
dynamically learned entries for the configured multicast group.
vlanid group-address group-mask}
vlanid group-address group-mask}
Multicast Commands
1029