Logging Audit - Dell PowerEdge M420 Reference Manual

Component Name
Thread ID
File Name
Line Number
Sequence Number
Message
Example
The following example places the designated server in logging configuration
mode.
console(config)#logging 192.168.15.1

logging audit

Use the logging audit command to enable switch auditing. Use the no form
of the command to disable switch auditing.
Syntax
logging audit
no logging audit
Default Configuration
The command default is enabled.
Command Mode
Global Configuration
Example
console(config)#logging audit
Component name for the logging component. Components
must use the new APIs in order to enable identification of the
logging component. Component UNKN is substituted for
components that do not use the new logging APIs.
The thread ID of the logging component.
The name of the file containing the invoking macro.
The line number which contains the invoking macro.
The message sequence number for this stack component.
Sequence numbers may be skipped because of filtering but are
always monotonically increasing on a per stack member basis.
An informative message regarding the event.
Syslog Commands
1521