Dell PowerEdge M420 Reference Manual page 556

Syntax
mvr type { receiver | source }
no mvr type
Parameter Description
Parameter
receiver
source
Default Configuration
The default value is None.
Command Mode
Interface Config
User Guidelines
The following table lists the completion messages.
Message Type
Successful Completion Message
Error Completion Message
Example
console(config)#mvr
console(config)#mvr group 239.1.1.1
console(config)#exit
console(config)#interface Gi1/0/1
console(config-if-Gi1/0/1)#switchport access vlan 10
console(config-if-Gi1/0/1)#mvr
console(config-if-Gi1/0/1)#mvr type receiver
556
Multicast VLAN Registration Commands
Description
Configure the port as a receiver port. Receiver ports are ports
over which multicast data will be sent but not received.
Configure the port as a source port. Source ports are ports over
which multicast data is received or sent.
Message Description
None
• Port is a Trunk port, operation failed.
• Receiver port in mVLAN, operation failed.