Installation - NEC Express5800 120Rj-2 User Manual

User Guide

Installation

Take the following steps to install a PCI board on the riser card:
■
Each riser card supports low-profile or full-height PCI
boards. Before installing a PCI board, check the type of the
PCI board.
■
When installing a PCI board, check that the card connector
matches the connector of the riser card.
1. See the section
2. Pull out the server from the rack.
3. Remove the logic cover.
4. Lift straight up and remove the riser card from the server.
If you feel difficult to remove the riser card, lift the riser card while pushing the
server chassis
"Preparing Your System for Upgrade" on page 137
Figure 120: Removing the Riser Card Assembly
Caution
169
www.nec-computers.com
to prepare.