Installing The Server Into A Rack; Before Installation - NEC Express5800 120Rj-2 User Manual

User Guide

Installing the Server into a Rack

This section provides the instructions to install the server into a standard EIA 19-inch
rack cabinet.

Before Installation

■
Do not use any rack which does not conform to the relevant
standard.
■
Disconnect the power cord(s) before installing or removing
the server.
■
Do not install the server on the rack leaving the cover
removed.
■
Do not pinch your finger with mechanical components.
Restricted Access Location
The server is intended for installation in a Restricted Access Location, mounted above
a non-combustible material.
Static Precautions
An electrostatic discharge (ESD) can damage disk drives, option boards, and other
components. You can provide some ESD protection by wearing an antistatic wrist strap
attached to chassis ground when handling server components.
Electronic devices can be easily damaged by static electricity. To prevent damage, keep
them in their protective packaging when they are not installed in your server.
Checking Components
Check that you have the components to install the server on the rack (screws, core nuts,
sliding rails).
Required Tools
Phillips screwdriver.
Warning
38
www.nec-computers.com