User Guide
Installing and Removing a Backup Device
The server has one slot for installing a backup device such as a magnetic tape drive.
■
A SCSI cable and a PCI SCSI controller card are necessary
to install a SCSI backup device.
■
Set "OFF" for the terminating resistor of the backup device
you are going to install, and set a SCSI ID different from
those of other devices. For the settings, see the manual pro-
vided with the server.
■
Install only a backup device specified by NEC.
■
The size of a backup device which can be installed in this
server is as follows:
Width: Up to about 9 cm (3.5 inches)
Height: Up to about 4 cm (1.6 inches)
Caution
0
1
2
Figure 141: Backup Device Slot
A: Backup device
189
www.nec-computers.com
3
4
5
A