Removal - NEC Express5800 120Rj-2 User Manual

User Guide
12. After the insertion, press the riser card down with your fingers until it is fully
seated.
Figure 127: Fully Sating the Riser Card Assembly
13. Install the components you removed previously.
14. Verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the
POST error messages listed in
15. Select "Yes" for [Advanced] → [Reset Configuration Data].
This setting is required to change the hardware configuration data. See
Setup Utility" on page 64
16. Start the BIOS configuration utility in the installed card, and set up the card.
Presence/absence of the utility and the start and operation methods depend on
the card. For details, see the manual provided with the card.

Removal

Remove a PCI board in reverse order of the installation steps.
"POST Error Messages" on page 200
for details.
173
www.nec-computers.com
.
"BIOS