NEC Express5800 120Rj-2 User Manual page 230

User Guide
During installation, the following warning is registered in the System Log of the Event
Viewer:
Error detected on the device \Device\CdRom0 during the paging operation.
- There is no problem on this issue.
Fail to start the OS:
■ Is a floppy disk in the floppy disk drive?
- Take out the floppy disk and restart the server.
■ Is the NEC ExpressBuilder DVD-ROM in the optical disc drive?
- Take out the NEC ExpressBuilder DVD-ROM and restart the server.
■ Is the OS broken?
- Use recovery process to recover the system. (See "Recovery for Windows 2000
System" in this Chapter.)
The OS presents unstable operation:
■ Did you update the system?
- Installing a network drive after installation of the OS may cause unstable opera-
tion. Use the NEC ExpressBuilder DVD-ROM to update the system.
The system does not restart automatically when a stop error occurs, though the
system is adjusted to automatically restarting:
- When the system does not restart automatically, restart it manually.
The system restarts automatically when a stop error occurs, though the system is
NOT adjusted to automatically restarting:
- There is no problem about this issue. Check the System Event Log to check that
STOP error occurred.
Cannot turn the power OFF at the blue screen:
- If you want to turn off the power at the blue screen, execute forced shutdown
(forced shutdown: continue to press POWER/SLEEP switch for 4 seconds). The
power will not be turned off if you press the switch for less than 3 seconds.
The PXE boot (network boot) fails or the server is not found on the network:
■ Is the cable connected properly?
- Connect the proper cable to the network port on the rear of the Express server.
In addition, make sure that the used cable conforms to the network interface
standard.
■ Is BIOS configuration correct?
230
www.nec-computers.com