NEC Express5800 120Rj-2 User Manual page 224

User Guide
■ Is BIOS configuration correct?
- Some devices connected to the serial or parallel port may require I/O port
address or operation mode settings. Refer to the manual that comes with the
board for details to make correct settings.
The Power switch and sleep features are disabled:
■ Ι s the POWER switch masked by the BIOS feature?
- The BIOS can disable power-off with the POWER switch after the operating
system is started (including shutdown by pressing the POWER switch for at
least four seconds).
Run the BIOS SETUP utility to change settings.
The keyboard or mouse fails to operate:
■
Is the cable properly connected?
- Make sure that the cable is connected to the correct connector on the rear of the
server.
- The keyboard or mouse does not operate if it is connected when the server is
powered (not applicable to USB devices). Power of the server first and connect
it properly.
■ Is the BIOS configuration correct?
- The keyboard and mouse may have been disabled with the BIOS SETUP utility
of the server. Check the settings with the BIOS SETUP utility.
■
Are the server drivers installed?
- Refer to the manual that comes with your OS to check that the keyboard and
mouse drivers are installed. (These drivers are installed along with the OS.)
Some OS's allow you to change the keyboard and mouse settings. Refer to man-
ual that comes with your OS to check that the keyboard and mouse settings are
correct.
Fail to access to the optical disc:
■
Is the optical disc properly set in the optical disc drive tray?
- The tray is provided with a holder to secure the optical disc. Make sure that the
optical disc is placed properly in the holder.
■
Is the optical disc applicable to the server?
- The optical disc for Macintosh is not available for use.
- The playback of an optical disc which does not conform to the optical disc stan-
dards is not guaranteed.
■
Is the optical disc drive bay correctly installed?
224
www.nec-computers.com