User Guide
Installing and Removing a Power Supply Unit
Your server contains one or two power supplies.
The second power supply is optional and provides a redundant configuration that
ensures continued operation of the system in the unlikely event one of the power
supplies fails.
Installation
Take the following steps to install a power supply unit:
1. See
"Preparing Your System for Upgrade" on page 137
Be sure to turn off the power. Failure to do so causes the server
to malfunction or fail.
2. Pull the cable arm toward the rear of the server, and check the slot for installing
an optional power supply unit.
3. Hold and pull the lever of the blank cover and remove the blank cover.
Figure 134: Removing the PSU Slot Blank Cover
Note: Keep the removed blank cover for future use.
Caution
181
www.nec-computers.com
.