Adding Onus To Olt - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide

14.4.2.3 Adding ONUs to OLT

ONUs can be configured only after they are added to the OLT successfully.
Context
l
l
Data Plan
Table 14-4 Key data plan
Item
DBA profile
Line profile
Networking
data
Procedure
Step 1 Configure GPON ONU profiles.
1.
Issue 01 (2014-04-30)
When adding ONUs, you need to bind related profiles to the ONUs, including the DBA
profile, line profile, and alarm profile.
An ONU can be added in two modes: offline addition and online confirmation. Select either
mode as required.
Data
Profile ID: 20
Profile type: Fixed bandwidth and minimum delay
DBA bandwidth:
l E1 access: 32 Mbit/s is recommended. (Each ONU accesses four E1
private lines and each line has a recommended DBA bandwidth of 8 Mbit/
s)
l T1 access: 24 Mbit/s is recommended. (Each ONU accesses four T1
private lines and each line has a recommended DBA bandwidth of 6 Mbit/
s)
Profile ID: 10
T-CONT ID: 1
GEM port ID for management service: 11
GEM port ID for DDN private line service: 12
PON port: 0/3/1
ONU parameters:
l ONU ID: 1
l SN: 32303131B39FD641
Configure a DBA profile. and set the DBA bandwidth allocation mode for the GPON port
to minimum bandwidth delay.
For example, configure the DBA profile for 4-channel E1 private line.
huawei(config)#dba-profile add profile-id 20 type1 fix 32768
huawei(config)#interface gpon 0/3
huawei(config-if-gpon-0/3)#port dba bandwidth-assignment-mode 1 min-loop-delay
huawei(config-if-gpon-0/3)#quit
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14 FTTM Configuration (Base Station Access)
1417