Configuring Management Service Ports On Olt And Onus - Huawei SmartAX MA5603T Configuration Manual

Access module
Hide thumbs Also See for SmartAX MA5603T:
Table of Contents

Advertisement

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Follow-up Procedure
When Config state is failed, Run state is offline, or Match state is mismatch:
l
l
l
l

13.3.1.4 Configuring Management Service Ports on OLT and ONUs

This topic describes how to configure management service ports (also called service flows) on
the OLT and ONUs. After the connections between the in-band management service ports on
the OLT and ONUs are reachable, you can log in to the ONUs on the OLT and configure the
ONUs.
Data Plan
Configuration
Item
Management
VLAN and
management IP
address for OLT
Management
VLAN and
management IP
address for ONU
NOTE
To log in to and configure an ONU remotely on the OLT, the management VLAN of the OLT must be the same
as that of the ONU, and the management IP address of the OLT and that of the ONU must be in the same network
segment.
Issue 01 (2014-04-30)
If Control flag is deactive, run the ont active command in GPON mode to activate the
ONU.
If Run state is offline, a physical line may be broken or the optical module may be damaged.
Check the line and the optical module.
If Config state is failed, the configured ONU capability exceeds the actual ONU capability.
In this case, run the display ont failed-configuration command in the diagnose mode to
check the failed configuration item and the failure cause. Then, rectify the fault accordingly.
If the ONU does not match, that is, Match state is mismatch, the port types and number
of ports undermatch the actual port types and number of ports supported by the ONU. In
this case, run the display ont capability command to query the actual capability of the
ONU, and then select one of the following modes to modify the ONU configuration:
– Create a proper ONU profile according to the actual capability of the ONU, and then
run the ont modify command to modify the configuration data of the ONU.
– Modify the ONU profile according to the actual capability of the ONU and save the
modification. Then, the ONU automatically recovers the configuration successfully.
Data
Management VLAN ID: 8
Management VLAN type: smart
In-band management IP address: 192.168.50.1/24
Management VLAN ID: 8
Management VLAN type: smart
In-band management IP address for ONU 1: 192.168.50.2/24
In-band management IP address for ONU 2: 192.168.50.3/24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 FTTO Configuration (Large-sized Enterprise Access)
1275

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartax ma5600tSmartax ma5608t

Table of Contents