Configuring The Btv Service - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

10.6.2.7 Configuring the BTV Service

The OLT is connected to the remote bridging ONU through a GPON port to provide users with
the multicast service.
Prerequisites
l
l
l
l
Issue 01 (2014-04-30)
Parameter
Mode
DHCP
NAT
c. Click OK to save the settings.
d. Choose Appliciation > Broadband Phone Configuration from the navigation
tree. Configure the parameters as follows:
Parameter
Address
Port ID
Enabling
User number
User
password
3. Restart the HGW.
Choose Management > Device Management and click Restarting the Device.
The OLT is connected to the BRAS and the multicast source.
The VLAN of the LAN switch port connected to the OLT is the same as the upstream
VLAN of the OLT.
The ONU has been added to the OLT. For details, see
OLT.
A VDSL2 port has been activated. For details, see
Port.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value
Route: route mode
Enabled
Enabled
Value
Preferred IP address of the proxy server: 200.200.200.200
Preferred signaling port ID of the proxy server: 5060
Enabled
When logging in to a VoIP account, you can set the user
account to the user telephone number. In this example, set
the user telephone number to 77730010.
-
10.6.1.4 Configuring a VDSL2 User
10 FTTD Configuration
10.6.2.3 Adding an ONU to an
803