Huawei SmartAX MA5603T Configuration Manual page 683

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
The following table describes the configuration steps.
Item
Optical
line
termina
l (OLT)
OLT
ONT
U2000
Issue 01 (2014-04-30)
Step
9.7.1.3 Adding an ONT to an OLT
9.7.3.4 Configuring the Internet
Access Service (on a Web Page or
the U2000)
Configure the 9.7.3.5
VoIP service. Configuring
the H.248-
based Voice
Service (on a
Web Page or
the U2000)
9.7.3.6
Configuring
the H.248-
based Voice
Service
(Through the
CLI)
9.7.3.7
Configuring
the SIP-based
Voice Service
(on a Web Page
or the U2000)
9.7.3.8
Configuring
the SIP-based
Voice Service
(Through the
CLI)
Configure the 9.7.3.9
IPTV service. Configuring
the BTV
Service
9.7.3.10
Configuring
the VoD
Service
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 FTTH Configuration
Description
Services can be configured for an ONT only
after the ONT is successfully added to an
OLT.
None
NOTE
l The H.248 and Session Initiation Protocol
(SIP) protocols are mutually exclusive for the
VoIP service. Either of them is configured at
a time.
l The voice service can be configured through
command line interface (CLI) on an OLT,
web page, or U2000. Select a configuration
mode based on site requirements.
l OLT CLI: This mode can be used for site
deployment or the U2000 has not been
deployed.
l Web page: This mode can be used to
configure voice parameters after the
service channel has been configured
through the OLT CLI. It can be used for
site deployment.
l U2000: This mode can be used to
configure voice parameters after the
service channel has been configured
through the OLT CLI. It can be used for
service provisioning in batches.
IPTV services include the BTV and VoD
services that are different in configuration
procedures and need to be configured
separately.
658