Example: Configuring The Eth Pwe3 To Emulate Ethernet Services On The Mpls Network - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
mpls-te enable standard-complying
network 192.168.2.0 0.0.0.255
network 5.5.5.5 0.0.0.0
return
config
interface tunnel 20
tunnel-protocol mpls te
destination 7.7.7.7
mpls te tunnel-id 20
mpls te signal-protocol rsvp-te
mpls te reserved-for-binding
mpls te commit
quit
tunnel-policy atmpw-plcy
tunnel binding destination 7.7.7.7 te tunnel 20
quit
pw-para 20
peer-address 7.7.7.7
pw-type atm nto1 vcc
control-word
vccv cc cw alert ttl cv lsp-ping
tnl-policy atmpw-plcy
quit
service-port vlan aoe adsl 0/2/0 vpi 0 vci 35 rx-cttr 6 tx-cttr 6
service-port vlan aoe atm 0/2/0 vpi 0 vci 35 rx-cttr 6 tx-cttr 6
pw-ac-bnding pvc 0/2/0 vpi 0 vci 35 outvpi 8 outvci 35 pw 20
static transmit-label 8450 receive-label 8460
4.3.3 Example: Configuring the ETH PWE3 to Emulate Ethernet
Services on the MPLS Network
The MA5600T/MA5603T/MA5608T supports the PW encapsulation for ethernet packets and
implements the ETH PWE3 emulation service after the MPLS encapsulation of the packets,
providing the solution of emulation Ethernet private line service over the MPLS network.
Service Requirements
l
l
Prerequisite
l
l
Context
The Ethernet packet-based data interaction between enterprise branches in different regions is
achieved using the routers of the public network to forward the packets. If the public network
uses the MPLS protocol, the Ethernet packets cannot be forwarded directly. In this case, the
Ethernet packet forwarding can be achieved by using the ETH PWE3 technology. In addition,
the ETH PWE3 technology can be deployed to achieve high security with low costs.
Issue 01 (2014-04-30)
The data interaction between enterprise branches in different regions is achieved through
the metropolitan area network (MAN) that is running the MPLS protocol.
The Ethernet service data of the enterprise private network is transparently transmitted so
that the data security can be ensured.
The SPUB board must be in position and must work in the normal state.
The static routing protocol or the OSPF protocol must be successfully configured on each
device in the network (the host route of each port must be successfully advertised).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuration Example of the Private Line Service
//xDSL access
//ATM access
414