Huawei SmartAX MA5603T Configuration Manual page 511

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
4.
5.
6.
7.
8.
Step 7 Configure the QinQ private line service.
MA5600T/MA5603T/MA5608T-1 and MA5600T/MA5603T/MA5608T-5 serve two branches
of a company to provide the QinQ private line service.
1.
2.
3.
Issue 01 (2014-04-30)
neglected
> Do you want to name the template (y/n) [n]:
> Please set the line-profile index (1~128) [1]:10
> Will you set channel configuration parameters? (y/n) [n]:y
> Please set the channel number (1~2) [1]:
> Channel1 configuration parameters:
> Please set the channel-profile index (1~128) [1]:10
Add template 10 successfully
Configure the VDSL2 alarm profile.
You can configure the VDSL2 alarm profile based on your requirements. For the
configuration, see "Configuring a VDSL2 Alarm Template." In this example, the default
alarm profile 1 is used.
Configure the VDSL2 traffic profile.
You can configure the VDSL2 traffic profile by running the traffic table ip command
based on your requirements.
In this example, the default profile (profile 6) is used.
Activate the VDSL2 port.
huawei(config)#interface vdsl 0/2
huawei(config-if-vdsl-0/2)#alarm-config all
huawei(config-if-vdsl-0/2)#activate all template-index 10
huawei(config-if-vdsl-0/2)#quit
Configure the upstream port.
l Configure the GIU board.
In general, the GE optical port uses the default gigabit full-duplex mode.
To change the mode, switch to the GIU config mode. Then run the speed command
to change the port rate, and run the duplex command to change the port duplex mode.
The settings of the upstream port must be the same as the settings on the peer device.
l Configure the VLAN.
The VDSL2 users of MA5600T/MA5603T/MA5608T-1 use the PPPoE
authentication. In this case, the smart VLAN is used to identify the users.
huawei(config)#vlan 1800 smart
huawei(config)#port vlan 1800 0/19 0
Add the service port.
All ports in slot 0/2 provide the VDSL2 Internet access service. To add service ports in
batches, run the multi-service-port command.
huawei(config)#multi-service-port vlan 1800 port 0/2 0-23 vpi 0 vci 35
user-encap pppoe rx-cttr 6 tx-cttr 6
Create VLAN 50.
huawei(config)#vlan 50 mux
Set VLAN50 as QinQ VLAN.
huawei(config)#vlan attrib 50 q-in-q
Add the upstream port.
huawei(config)#port vlan 50 0/19 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Configuration Example of MSTP Subtending Network
486